Tektronix THS710A Uživatelský manuál stáhnout pdf (Strana 61)

Performance Verification

THS710A, THS720A, THS730A & THS720P Service Manual

4–17

3. Set the leveled sine wave generator frequency to 200 MHz if you are

checking a THS730A or to 100 MHz if you are checking a THS710A,

THS720A or THS720P.

4. Set the TekScope instrument VOLTS/DIV to 500 mV/div.

5. Set the leveled sine wave generator output level to approximately 50 mV

p-p

so that the measured amplitude is approximately 500 mV. (The measured

amplitude can fluctuate around 500 mV.)

6. Press SET LEVEL TO 50%. Adjust TRIGGER LEVEL as necessary and

then check that triggering is stable.

7. Change the TekScope instrument setup using the following steps:

SCOPE TRIGGER Slope \ (falling edge)

8. Press SET LEVEL TO 50%. Adjust TRIGGER LEVEL as necessary and

then check that triggering is stable.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 141 142

Žádné komentáře

Tektronix THS710A Uživatelský manuál Strana 61