Tektronix Phaser 600 Uživatelský manuál Strana 504

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 798
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 503
CONNECTING A SCSI HARD DISK
488
Phaser Copystation:
If you have a Phaser Copystation connected to the printer, it must be
located at one end of the SCSI chain, with the printer at the other end
and the external disk(s) in the middle.
The Copystation uses two SCSI ID addresses, 5 and 6; therefore, the
external disk(s) can use ID numbers 0 through 3. If you set an external
disk to SCSI ID address 5 or 6, you may see an error on the
configuration or startup pages.
Sys/Start
file:
You may load a startup file called
Sys/Start
onto your external disk. The
Sys/Start
job file is similar to an init file. When you turn on the printer
the file executes, providing that
Sys/Start
has been enabled through a
control file downloaded to the printer. Refer to Enab
ling and disabling
SysStart Job execution for more information.
NOTE
If the
Sys/Start
file contains an error, the printer ignores the remainder of the file and
may not start up as expected.
Zobrazit stránku 503
1 2 ... 499 500 501 502 503 504 505 506 507 508 509 ... 797 798

Komentáře k této Příručce

Žádné komentáře