
Commands Listed in Alphabetical Order
Trigger on ID
Trigger
in IDANDDATA
Conditions
This command requires a DPO4AUTO applic ation module.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:CAN{:ID entifier|:ADDRess}:MODe
{STandard|EXTended}
TRIGger:A:BUS:B<x>:CAN{:ID entifier|:ADDRess}:MODe?
Arguments
STandard specifi es the standard addressing mode.
EXTended specifies the extended addressing mode.
TRIGger:A:BUS:B<x>:CAN{:IDentifier|:ADDRess}:VALue
Sets or returns the binary address string used for a CAN trigger if the trigger
condition is ID o r IDANDDATA. Applies to bus <x>, where x is the bus number.
Conditions
This command requires a DPO4AUTO applic ation module.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:CAN{:ID entifier|:ADDRess}:VALue <QString>
TRIGger:A:BUS:B<x>:CAN{:ID entifier|:ADDRess}:VALue?
Arguments
<QString> is up to 29 bits specifying the binary CAN identifier value. The only
allowedcharactersinthe
QString are 0, 1, and X.
Examples
TRIGGER:A:BUS:B1:CAN:IDENT IFIER:VALUE 1011 sets the CAN trigger
identifier value to 1011.
TRIGger:A:BUS:B<x>:FLEXray:CONDition
Sets or returns the trigger condition for FLEXRAY.
Group
Trigger
MSO4000 and DPO4000 Series Programmer Manual 2-401
Komentáře k této Příručce